Save Energy And Cash This Winter - Improve Your Home With Double Glazing And Insulation
Over 20% of the heat lost from your property goes straight out of the roof, so it is necessary that you've the attic properly insulated. Even when your attic was insulated when the house was constructed or any time earlier than the final couple of years, it might not have the right amount of insulation.
Current government suggestions have virtually doubled the recommended quantity of insulation, and a minimal thickness of 200-250 mm (8 - 10 inches) is now urged in temperate areas.
In the event you do need to top up your attic insulation, it's easy to do it your self in a couple of hours if you're reasonably good at DIY. You don't need any special instruments or abilities and it may be less expensive than paying someone else to do it - as long as you do not put your foot by way of the ceiling!
But check before you begin as grants may be available to assist with part or the entire price of insulation, especially for the aged or those on a low income or benefit. For those who do determine on the DIY route, remember that some types of insulation are irritants so put on suitable clothing, together with gloves, goggles and a facemask if you end up laying the insulating material.
Ensure you rigorously observe the instructions that include the insulation, and particularly ensure that you don't block ventilators or air inlets. Leave a niche around the eaves as effectively to prevent condensation.
Do not cover electrical cables and keep insulation away from objects equivalent to recessed light fittings that may require airflow to forestall overheating - check when you're not sure.
The attic will likely be lots colder as soon as it is insulated so make sure that pipes are lagged and water tanks are insulated. Do not insulate below tanks though - leaving a clear area beneath will allow heat from below to rise and help cease them freezing. Finally don't forget to insulate and draft proof the access hatch.
Now that the attic is comfortable, it's time to take a look at some of the different areas you could work on to cut down on the heating bills.
Double glazing your home windows is best at retaining warmth, but in case you don't need to change your old sash windows just yet, it can save you energy by stopping drafts. Seal or caulk any gaps around the body utilizing a sealant gun and cartridge - your native DIY or hardware retailer needs to be able to advise you on the most effective type on your needs. However whatever sealant you employ, first be certain that all the surfaces are clean and dry and that there isn't any loose or flaking paint which could prevent the sealant adhering.
Fit weather strips to opening home windows and doorways - these come in many shapes and sizes ranging from low-cost and straightforward to fit self-adhesive foam rubber strips to more expensive however durable plastic or metal climate stripping. Prevent drafts under doors by installing an adjustable threshold or brush type strip at the bottom of the door.
As soon as the frames are weatherproofed, you possibly can look at reducing heat loss through the window glass itself. The most affordable manner of doing this is to make use of a clear film plastic sheeting which is caught to the window body with tape and then warmed with a hairdryer. This causes the plastic film to shrink and tighten removing wrinkles and creases. This type of magnetic secondary glazing glazing - while low priced - needs to be renewed if you need to access the window, and so is unsuitable for windows which you wish to open before spring!